Sign Finder  /  Industries

Sawmill, Pulp & Paper Mill Safety Signs

Every sign is written for a specific machine, task or install point in this industry.

Setting up a sawmill or wood shop? Answer a few questions and get every sign you need, room by room, with quantities and where each one goes. Takes about two minutes.
Plan my site

A sawmill runs on equipment that does not forgive a slip: log decks that roll, debarkers that grab, band saws, chippers and a planer mill full of chains and sorters. A paper mill adds steam, nip points on rolls that move faster than anyone can react, and the chemicals that cook the pulp.

These signs are written for those exact machines and spots, from the log yard to the dry kilns and from the pulper to the winder. Each one is 8x12 aluminum with pre-drilled holes for a guard, rail or machine frame, and it stays readable through sawdust, steam and washdown.

What to post, and where

Log yards and log decks

Loaders, log decks and the yard traffic around them. 65 signs. Typical spot: Carriage deck and turner arms.

Debarkers

Drum and ring debarkers, bark conveyors and the platforms above them. 154 signs. Typical spot: Rotor guard access doors and debarker platform.

Head rig and saw line

Band saws, carriages, edgers and trimmers on the main line. 167 signs. Typical spot: Walkways beside the band mill and carriage.

Chippers and hogs

Chippers, hogs and the chip handling that follows them. 152 signs. Typical spot: Pile perimeter and access roads.

Planer mill, sorters and stackers

Planers, sorters, stackers and the chains between them. 127 signs. Typical spot: Trimmer saw line and lug chain.

Dry kilns

Kiln doors, fans, baffles and the heat inside. 177 signs. Typical spot: Kiln door openings.

Paper machines and winders

Nip points, dryer sections, reels and winders. 178 signs. Typical spot: Hood doors.

Pulpers, digesters and chemical areas

Pulpers, digesters and the chemicals used to make pulp. 232 signs. Typical spot: Mount on or beside the pulper sump pump where workers approach it.

Common questions

What safety signs does a sawmill need?

Start at the machines with the worst outcomes: the debarker and log deck, the head rig and saw line, the chipper and hog, and the kilns. Then add lockout reminders at each control station. The Sign Finder lists signs for each one by install point.

Do you have signs for paper machines and winders?

Yes, including nip points, jog controls, lockout boards and broke chutes. Search "paper machine" to see them.

Will these hold up to sawdust and steam?

Yes. They are rust-resistant aluminum with UV-stable print, and they wipe clean, so they stay readable in dusty and damp mills.

Browse every sign